Hi, I'm Sara Madani A continuous learner & Ph.D of Chemical engineering [email protected] Educations 2013 -2021 Amirkabir University of Technology Ph.D. Chemical Engineering (GPA: 18.04/ 20) Tehran, Iran Dissertation: Novel Graphene-Based Electrodes for Capacitive Deionization (CDI): Fabrication, Characterization and Operation Assessment 2009 -2011 Ferdowsi University of Mashhad M.S. Chemical Engineering, Separation and Transport Phenomena (GPA: 18.28/ 20) Mashahd, Iran Thesis: Improvement of Microbial Fuel Cells’ Performance 2003-2008 Ferdowsi University of Mashhad B.S. Chemical Engineering (Gas Processing) Mashahd, Iran Thesis: Technical and Economical Investigation of Heterogeneous Conversion of Toluene in Reactive Distillation Columns. Research & Works 2013-2021 Research Assistant, Amirkabir University of Technology, Supervisors: Dr. Cavus Falamaki and Dr. Seyed Hamed AboutalebiCharacterization of Ultra large Graphene Oxid (UGO), UGO Foam, and composite of CNT-UGO-Activated carbonWorking on a novel analytical approach for Geometrical characterization of UGOSupercapacitor tests of UGO foam and electrochemical assessment of graphene-based compositesConstructing CDI module and assessment of CDI performance by real testsModeling of multicomponent CDI electrodes and optimization 2016-2021 Researcher, Institute for Research in Fundamental Sciences (IPM)- Condensed Matter National LaboratorySupervisor: Seyed Hamed AboutalebiUltra large graphene oxide (UGO) synthesisCharacterization of reduced form of UGO read more... Hands-on Experience Design of electronic board for datalogging and a micro controller by AVR programming for CDI systemCylindrical MFCAir cathode MFCsConstruction of the Large-size flow cells for dynamic electrochemical testsMunicipal waste water with brush Anode and Air cathode in a two-chamber microbial fuel cell Previous Next read more...